Cart
0
Product
Products
(empty)
No products
To be determined
Shipping
$0.00
Total
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart.
There is 1 item in your cart.
Total products
Total shipping
To be determined
Total
Sale!
View larger
View larger
GMW16830
New product
GMW16830 2nd Edition, July 1, 2017 Tape Lamination to Automotive Components
More info
Description / Abstract:
Introduction
Note: Nothing in this standard supercedes applicable laws and regulations.
Note: In the event of conflict between the English and domestic language, the English language shall take precedence.
Purpose This standard describes a daily quality procedure for running a 90 degrees peel test between the tape and the component. The quality of the bond between the tape, and the component can be determined by peel strength, and the failure mode observed. Tape attached components can include body side moldings, emblems, nameplates, body claddings, appliqués, door sill plates, fascia trim strip, wheel flares, roof ditch moldings, and other trim applications.
Applicability
Raw Material Approvals. This specification applies only to substrates, adhesion promoters, and tapes that have been qualified and approved to the appropriate GM specifications.
Note: Nothing in this standard supercedes applicable laws and regulations.
Note: In the event of conflict between the English and domestic language, the English language shall take precedence.
Purpose This standard describes a daily quality procedure for running a 90 degrees peel test between the tape and the component. The quality of the bond between the tape, and the component can be determined by peel strength, and the failure mode observed. Tape attached components can include body side moldings, emblems, nameplates, body claddings, appliqués, door sill plates, fascia trim strip, wheel flares, roof ditch moldings, and other trim applications.
Applicability
Raw Material Approvals. This specification applies only to substrates, adhesion promoters, and tapes that have been qualified and approved to the appropriate GM specifications.