Cart
0
Product
Products
(empty)
No products
To be determined
Shipping
$0.00
Total
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart.
There is 1 item in your cart.
Total products
Total shipping
To be determined
Total
Sale!
View larger
View larger
More info
Description / Abstract:
Introduction
Note: Nothing in this standard supercedes applicable laws and regulations.
Note: In the event of conflict between the English and domestic language, the English language shall take precedence.
Purpose.
This standard describes the general requirements for the quality and appearance of soldered connections and contains general instructions on the soldering procedure, so far as this is not described in detail on the drawings.
Applicability.
This standard can be used for soldered connections in motor vehicles.
Remarks.
Soldered connections can be classified according to design, soldering procedure and scope.
The soldering design can be, for example, flat/overlap or inserted joint connections.
The joining procedures are soldering and brazing.
This classification is specified in DIN 8505-2 and DIN 8505-3.
This specification is classified according to the scope:
Type A: Tube connections made of aluminum and/or aluminum alloys used, for example, heat exchangers, air conditioning equipment etc.
Type B: Flat products and profiles, made of aluminum and/or aluminum alloys.
Type C: Tube connections made of steel, for example, fuel lines.
Note: Nothing in this standard supercedes applicable laws and regulations.
Note: In the event of conflict between the English and domestic language, the English language shall take precedence.
Purpose.
This standard describes the general requirements for the quality and appearance of soldered connections and contains general instructions on the soldering procedure, so far as this is not described in detail on the drawings.
Applicability.
This standard can be used for soldered connections in motor vehicles.
Remarks.
Soldered connections can be classified according to design, soldering procedure and scope.
The soldering design can be, for example, flat/overlap or inserted joint connections.
The joining procedures are soldering and brazing.
This classification is specified in DIN 8505-2 and DIN 8505-3.
This specification is classified according to the scope:
Type A: Tube connections made of aluminum and/or aluminum alloys used, for example, heat exchangers, air conditioning equipment etc.
Type B: Flat products and profiles, made of aluminum and/or aluminum alloys.
Type C: Tube connections made of steel, for example, fuel lines.